cura 4.3 asks for printer setup everytime it is stated after a windows restart.

[bman 2]

I have been using version 4.3 and have imported my configurations from previous versions. Most of the time when I start my computer and open Cura I am prompted by the initial screens and license. I am then walked through the printer selection wizard. The wizard does not show my profiled printers, but asks for new ones to be added. Once I add a new printer Cura takes me to the main screen where I can select all of my already installed printers and profiles.

[nallath 1,123]

Could you share your log files?

 

My initial guess would be that it's failing to write files to your harddrive (since thats how the machines are stored).

[bman 2]

Here you go. I tried to remove the old cura folders but that did not seem to help.

 

Thank you

 

Bernie

cura.log

[nallath 1,123]

I'm seeing some issues in the log, but I'm not quite sure if they are causing the issues;
- There is a (custom) plugin that is failing to be loaded called the "MKS Plugin".

- There is a printer that doesn't have a definition set called BIBO2. This is probably the result of manually adding a printer definition and not adding all the files it needs.

[bman 2]

Those profile was added by the manufacturer. It works fine inversion 3, and does work in version 4 once you select a new printer and get past the wizard.

[cambuehl 0]

Same problem for me, only all the time not just after a windows restart.  Cura worked great for about 2 weeks then started asking for setup again at nearly every launch.  I've just started opening a half dozen instances of cura back-to-back and usually at least 1 of them will open the way it should, without asking to go through setup again.  It's a ridiculous workaround, but it seems to work.  Hopefully with the next update you can address this issue!

Edited February 23, 2020 by cambuehl