When I replace my nozzles it will blather about this configuration is not calibrated, so I run the calibration (see attached) I can move the calibration in .5 increments but .1 would be much closer to what I need.
Ok got it 😀
And you cannot choose 3 or 12 for example? I haven't calibrated for a long time but as far as I remember I was able to choose any number from the sheet.
I am currently printing a 3 day job I'll post screen shots of my next calibration
-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
Smithy 1,144
Can you please be a little bit more specific and elaborate what you mean exactly?
What do you want to adjust and where?
Link to post
Share on other sites