How to prevent specific print path

[wal_ter 0]

Hi everyone,

 

I did not finde a good title. Any Ideas?

 

I want to print the following structure with Cura 4.4. The structure is almost cylindrical.

It is slightly conical with a 0,5 degree draft angle.

The diameter at the bottom of the structure is 3mm.

It is part of a case where a screw will be screwed in.

 

The next image shows a cross section of the lower area.

I print with a 0.2mm nozzle.

The yellow print path lead to problems. It is not circular like the green and red paths.

Does anyone know how to prevent the yellow print paths?

I would like to have circular print paths at the whole cross section.

 

[Smithy 1,144]

Please save the project (File -> Save) and attach the .3mf file to this thread so we can check it out.