WARNING could not save - [Errno 28] no space left on device

[h2befjon 1]

Hello,

I have a ultimaker 2+, I'm using the supplied 4gb micro SD card and cura 4.4.0. I have plenty of space in my SD card and I'm not sure what is causing the error. 

 

Also, I updated the ultimaker 2 + firmware through the cura app but I can't find any information on what the update was for.

 

Can someone help me with this issue?

[Job_van_gennip 23]

I once had this when i by accident had switched the data lock on the sd card. Could you check if the little switch is in the right position?