-
Our picks
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
UltiMaker Cura 5.9 stable released!
ArunC posted a topic in UltiMaker Cura,
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more-
-
- 5 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 4 replies
Picked By
MariMakes, -
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
Recommended Posts
Smithy 1,146
Hi and welcome!
I am not sure if I understood your question, recovery and backup are different things, but I will try to answer it.
There is no option to backup your firmware, and in my opinion it is not really needed, there are only a few settings so you can quickly setup the printer again without restoring a backup.
A recovery from what? Is your printer bricked and not working at all? Then there exists a recovery option but depends on your printer model.
Or do you just want to reset everything, then use the factory reset from the menu.
Link to post
Share on other sites
gr5 2,267
Which UM printer do you have? Instructions for recovery vary depending.
Link to post
Share on other sites