Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
It used to be in cura that it would print them in the same order as you load them. Maybe. Although it prints the parts on the "ends" twice (with a layer shift in between).
Anyway one solution might be to wait one layer and every other layer it should reverse directions (I think).
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.
Recommended Posts
gr5 1,872
It used to be in cura that it would print them in the same order as you load them. Maybe. Although it prints the parts on the "ends" twice (with a layer shift in between).
Anyway one solution might be to wait one layer and every other layer it should reverse directions (I think).
Link to post
Share on other sites