Ask how to set up Raft in Cura

[Ares 0]

I use 4.4.0 Cura.

I set up Airgap on Raft.

But it did not apply to support.

I am looking for a way to solve the above problem.

[gr5 2,266]

Sorry I'm not answering your question but I hope I can be helpful anyway.

 

Is this PLA?  What kind of printer is this?  Raft is an old technology already on it's way out before Cura was written.  Because of this I suspect it doesn't work very well in Cura (probably works better in slic3r).

 

You shouldn't need a raft unless you are printing high temp materials (like ABS) and don't have a heated bed.  Is that the case?  Do you have a heated bed?

Are you printing something other than PLA?

 

I have more information about this topic here: