Jump to content

Cura does not run when Malwarebytes Antimalware is active

psl_lo

By psl_lo
in UltiMaker Cura

 Share

Recommended Posts

psl_lo

psl_lo 0

Posted
Posted · Cura does not run when Malwarebytes Antimalware is active

I'm running Windows 10. For sometime now, Cura 4.x loads but does not run if Malwarebytes Antimalware 4.x software is active.

The only way I've found for Cura to successfully run is to either quit Malwarebytes or add Cura.exe to the exclusion list in the detection settings in Malwarebytes.

Have there been any other reports of this undesirable interaction between Cura and Malwarebytes ?

    • Link to post
    Share on other sites
    DivingDuck

    DivingDuck 105

    Posted
    Posted (edited) · Cura does not run when Malwarebytes Antimalware is active

    A well known problem at all. Some other AV kits have this problem as well. This is something that you have to solve, contact Malewarebytes and complain this behavior. Ultimaker can't solve it for you.

    Edited by DivingDuck
    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • Introducing the UltiMaker Factor 4

        Introducing the UltiMaker Factor 4

        ArunC posted a topic in UltiMaker 3D printers,

        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
        MariMakes

        Picked By

        MariMakes,
      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...