Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up
Minkeproducts

Any advice how to tighten pulley on left stepper motor?

Recommended Posts

Posted · Any advice how to tighten pulley on left stepper motor?

Dear all,

 

Concerning my post how to solve shifted layer issue, I try to tighten the pulley on the left stepper motor (see photo pasted hereunder)

I removed the metal shield, I loosened the whole mechanism, but I find difficulty to understand how I can tighten the pulley again?

Is there some kind of manual or video or images where I can find the procedure to re-assemble it?

I have a problem to reach the pulley with the hexagon screwdriver, how do I do that?

Thanks for your help?

 

IMG_20200203_132526.jpg

Share this post


Link to post
Share on other sites
Posted · Any advice how to tighten pulley on left stepper motor?

Thank you @Emerald, your link is very helpful. Still I am missing information how to tighten the pulley connected most nearby the left stepper motor (photo attached)

Shouldn't I have loosened it? Or do I need to tighten it befóre re-assembling the short -belt block sitting around it?

 

Minke

IMG_20200203_132526.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...