WiFi hotspot takes years to be created

[msyukri43 0]

Hello, my Ultimaker S3 Extended couldn't create the WiFi hotspot. I have waited for half a day and it still stuck on this message. I have rebooted, updated to latest firmware, reset to factory setting but the problem still persist. I have addressed the problem to my local distributor but I still haven't get any feedback ever since. 

 

[Dim3nsioneer 557]

Please also try a Cura Connect reset. If you reboot, leave the printer off for a few minutes.

 

If all fails, a firmware recovery might help:

Be aware that you loose all calibration data with a recovery.