UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
This is a common problem with machine settings. Go into the machine settings for your printer. There should be a checkbox for where the origin (0,0) is located. Uncheck that. For delta printers you usually want that in the center of the printer so the gcode includes equal amounts of positive and negative values.
For pretty much all other printers you want that in the lower left corner. So cura thinks you have a delta printer for some reason. Anyway just make sure origin is set to lower left corner (not center of bed).
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,224
This is a common problem with machine settings. Go into the machine settings for your printer. There should be a checkbox for where the origin (0,0) is located. Uncheck that. For delta printers you usually want that in the center of the printer so the gcode includes equal amounts of positive and negative values.
For pretty much all other printers you want that in the lower left corner. So cura thinks you have a delta printer for some reason. Anyway just make sure origin is set to lower left corner (not center of bed).
Link to post
Share on other sites