As far as I know there is no animation of the tool-chain in CURA 4.6. If you are aware of this feature then please let me know how you invoke it.
The play button (purple in above screen capture) is used to start\restart the slicer, the results of which are displayed when it completes . Changes to the top layers and 5 detailed layers (grey) can effect what is shown and the slider (black) lets you move up and down in the model layer to show the detail around the chosen level.
If you are saying that the resultant gcode, when run, only prints the top layer then you also have me stumped.
Hope this helps
Recommended Posts
Hotpoint 1
There should be a slider bar on the RHS that lets you adjust the visable layer from top to bottom.
Link to post
Share on other sites
Kevin005 0
I already have the slider set so all layers should be visible and only printing the top layer.
Link to post
Share on other sites