I did not reflect your model for sure, but this is a general thing all the time during printing. I have never tried to measure this "normal violent" acceleration/deceleration bu I am sure it is very hi.. 🙂
Rgeards
Torgeir
I did not reflect your model for sure, but this is a general thing all the time during printing. I have never tried to measure this "normal violent" acceleration/deceleration bu I am sure it is very hi.. 🙂
Rgeards
Torgeir
The graph is of the M106 (Fan speed) values versus G0 (Z) values taken directly from the GCode. The "bounce" is actually in the code.
That's clear up for sure, hmm...
I'm kind of slow today.
Torgeir
Good catch.
Torgeir.
11 minutes ago, Torgeir said:Good catch.
Torgeir.
Thank you 🙂
Recommended Posts
chrisr 18
Hi Torgeir I agree, but it's hard coded into the Gcode.
Link to post
Share on other sites