Change Printcore not working

[deltatron 0]

Hi,

after calibrating the axle the printer is not able to change the Printcore. In front of the calibrating the Head with the printcores is going to the right side of the printer and could change the printcore. One of them is going up and the other one was in use. Now, the Head is not going to the correct  position with the plastic part to switch the core. The head is about a few cm behind the correct position.

I'm not sure why and I don't have any idea to solve the issue.

 

I am grateful for any hint.

 

Thanks,

Heribert

[IRobertI 521]

Do a lift switch calibration and you should be good to go:

https://support.ultimaker.com/hc/en-us/articles/360011474120-Lift-switch-calibration

[deltatron 0]

Thanks a lot. It works well.

You are the best.