It's confusing but you can go to the filament menu and change the default temperatures for PLA. Everytime I do this it is very confusing and takes me 3 tries and I never know exactly what order to hit the buttons but it is possible to do this. You know you got it when you are done you can select PLA as the filament and it starts heating to the new temperatures.
Recommended Posts
illuminarti 18
Cura has Save Profile and Open Profile in the File menu. Also, if you're slicing for something other than the UM2, then Cura writes all of the settings used into every gcode file that you produce, and then you can reload them using File -> Load Profile from Gcode.
Link to post
Share on other sites