UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
The support doesn't show up in the 3D view of the part - you need to change to the layers view to see it. But then you should see it (it shows up as blue lines, iirc). The positioning of the support will depend on the overhang angle of the print, so there might be less than you expect.
Another Cura release has arrived and in this 5.8 beta release, the focus is on improving Z seams, as well as completing support for the full Method series of printers by introducing a profile for the UltiMaker Method.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
illuminarti 18
The support doesn't show up in the 3D view of the part - you need to change to the layers view to see it. But then you should see it (it shows up as blue lines, iirc). The positioning of the support will depend on the overhang angle of the print, so there might be less than you expect.
Link to post
Share on other sites