Triangle Printing before project

[starwarsmasterq 0]

Good Morning,

        When I use Ultimaker Cure 4.7, before my print start I get a triangle that forms and I have to peal it off to have my actual print. If I don’t remove it then it will mess up my first layer. Has there been a patch in the program or a change ican make in the G-code or anything to where that does not happen and it just does the line on the far left edge and it does not get in the way of my first layer?

 

[Framar 38]

I remember someone else had the same problem in the past. Make a search on the forum and should find the solution.

[GregValiant 1,304]

Popular problem apparently How do I remove this triangle