Hi Charles,
As the bowden tube is removed you can just lift up the withe locking ring, now you'll have enough space to use a "long" a tanned tip rod to grab that filament.
Heat the nozzle to 200 deg. C., then pull it out, but be careful and not clamp the filament to hard.
Never over temp the filament, as this might harden filament very much and destroy your print core.
Anyway, good luck.
Thanks Torgeir
Edited by TorgeirText.
Recommended Posts
RonaldKeller 0
Hello Charles,
I am very new to 3D printing so I am certainly a beginner but I would think you should be able to pull the filament out if you heat up the print core. I know you said it did not work cold nor hot. But I think you should try again by heating the core. Maybe by setting the temperature VERY high it should work.
You can achieve this (as you probably know) by going in the printer's menu.
(English is not my native language so I hope you understand what I meant)
Ronald
Link to post
Share on other sites