Jump to content

Glass bed upgrade


Recommended Posts

Posted · Glass bed upgrade

They're like motorcycle saddles...If you are happy with the one you have why change?  You might get glass and hate it.

 

I like mine (from Creality).  I use hairspray as an adhesive.  Sometimes things stick overly well but the handy dandy putty knife and a tap with a little shoe repair hammer convinces the parts to release.  The hard part to deal with is the clips because there are times when the print head will need to go where the clips are.  I finally glued some small aluminum angles to the underside of the metal bed and they act as edge locators for the glass.  No clips at all.  It was either that or start wearing safety glasses when I was printing.  I'd forget about the clips and the printer would shoot them right across the room.

  • Thanks 1
Link to post
Share on other sites

  • 3 weeks later...
Posted · Glass bed upgrade

They started life as 1" x 1" x 1/16" aluminum angle.  I cut them down to 9mm x 9mm x 20mm long.  A spot of super glue holds them to the underside (better that they are easy to remove).  I put on the right side and 1 back piece hard against the edges of the hot plate and let the glue set.  Then slid the glass in place up against them and glued the other pieces on to trap the glass (the glass is slightly larger than the hot plate).  For small prints I usually don't bother with the clips, but for larger nervous pieces I use the clips.  That's a belts-and-suspenders approach but it helps keep my anxiety down.

 

DSCN2515.thumb.JPG.7ad5a271e6c2b26e92a71786f80ac152.JPG

 

DSCN2516.thumb.JPG.8cc6b01f94a0d904f58747ef4d2d5434.JPG

 

DSCN2517.thumb.JPG.20c7862aceb2cba4bedb6a9381c05d6e.JPG

The front left piece isn't missing.  I didn't put one there because it's the home position and when I extruded prior to the start of a print it was hitting that clip and making a mess.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...