I saved and sliced my print in cura but only part of it finshed i attached picture of final result + file

[johnboyman 0]

Hello all I saved and sliced my print in cura but only part of itfinshed i attached picture of final result + the file. I think the problem may be the roof laking supports i attached an image of this hope that somone can figure this out.

Edited December 30, 2020 by johnboyman

[kmanstudios 1,120]

Gonna go out on a limb and conjecture that the missing parts are due to a bunch of open edged polygons that cannot be printed.

 

Having access to the actual file (STL for the model only and '.3mf' for project file) is much more preferred.