UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Try re-formatting the SD card and blow out the card slot in the printer. Have you ever used Cura to send a print over the USB? If you have, and you know the computer and printer can communicate, then you can hook it up to the computer, start Cura, load a gcode file (or slice something) and go to the Monitor screen. Try sending G28 from Cura and see if it the printer homes.
If that stuff doesn't work you can try sending M502. That will do a full reset back to factory defaults. You will lose your Home Offsets and Steps/mm calibration stuff. You should be able to get those from the printer before you reset it and then you can just re-enter them afterwards. When this happens though it's often the SD card.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
GregValiant 1,351
Try re-formatting the SD card and blow out the card slot in the printer. Have you ever used Cura to send a print over the USB? If you have, and you know the computer and printer can communicate, then you can hook it up to the computer, start Cura, load a gcode file (or slice something) and go to the Monitor screen. Try sending G28 from Cura and see if it the printer homes.
If that stuff doesn't work you can try sending M502. That will do a full reset back to factory defaults. You will lose your Home Offsets and Steps/mm calibration stuff. You should be able to get those from the printer before you reset it and then you can just re-enter them afterwards. When this happens though it's often the SD card.
Link to post
Share on other sites
jeff5 1
Changing the SD card and blowing out the printer worked. Thank you
Link to post
Share on other sites