Thank you for your time and help. The g-code printed just fine.
Somehow loading the .3mf into my cura slicer still produced the same result of one layer sliced.
However, since I was able to print my part I'm going to table this mystery for now.
Again, thank you for your help.
Dan
Recommended Posts
juspch 0
Not sure what's causing your issue as loading the .3mf is fine in my slicer.
In case you don't figure out what's wrong in time, here's the sliced file with the settings you had in the .3mf for a CR-10S. This is for a 0.4 mm nozzle, PLA print by the way.
CE3_SBFB-SPRING.gcode
Edited by juspchLink to post
Share on other sites