UNKOWN ERROR

[adam_pro_onine 0]

Hi All,

Would appreciate some help.

My ultimaker S5 pro bundle finished the first spool I used, upon finishing it appeared to have been unable to dislodge the filament end from the spool. Long story short - im 59 hours into a 62 hour print, I have no material (Because the spool was done) but the printer has not detected the end of the spool, I cannot change the material to a new spool, all available options appear blank, the material won't eject, and it now claims to have an extrusion problem (which I doubt after 2 prints).

I'm also conscious maintainable on all parts will end up losing the print.

 

Overall on first impressions, this eyewateringly expensive FFF printer is pretty poor and highly overengineered.

Edited February 23, 2021 by adam_pro_onine