16 minutes ago, GregValiant said:How are the lower layers on other prints? Does it do that if printed in PLA?
Not Sure, I haven't tried this part (or any vase mode parts) on this printer yet in PLA.
Edited by Jdo30016 minutes ago, GregValiant said:How are the lower layers on other prints? Does it do that if printed in PLA?
Not Sure, I haven't tried this part (or any vase mode parts) on this printer yet in PLA.
Edited by Jdo300Not just vase mode prints, do the bottoms on any of your prints on that machine show that smashed look? I'm asking because if that was a Creality printer I'd be thinking about Z-binding near the build plate which goes away as it gets higher.
Recommended Posts
GregValiant 1,342
How are the lower layers on other prints? Does it do that if printed in PLA?
Link to post
Share on other sites