-
Our picks
-
UltiMaker Cura 5.8 Stable released 🎉
MariMakes posted a topic in UltiMaker Cura,
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!-
- 5 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
Picked By
MariMakes, -
-
Recommended Posts
gr5 2,235
I don't know but the 0.9 deg steppers doesn't matter. This only affects the setting "steps/mm" which is on the printer itself and should be already in the firmware before they ship the printer.
It's probably the same printer profile as for the other biqu printer (if it's in cura already). It's up to companies that make these printers to get them added into cura or to provide instructions on how to setup your printer in cura. Perhaps they published instructions. Likely (hopefully) they did.
Link to post
Share on other sites