-
Our picks
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
UltiMaker Cura 5.9 stable released!
ArunC posted a topic in UltiMaker Cura,
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more-
-
- 5 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 4 replies
Picked By
MariMakes, -
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
Recommended Posts
tinkergnome 927
It depends... it is explicitely allowed to ask a bit more elaborate questions here...
Welcome to the forum btw. 🙂
I assume it's a non-Ultimaker printer, but i can only guess. If the "bring bed to front" move is caused by Cura at all..., it is probably part of the end-script. This can be customized in the machine settings. So: in Cura activate the printer in question, go to "Manage printers -> Machine settings" and modify the script for "End G-code".
In addition: it is unlikely but still possible that the firmware of the printer is responsible for this behavior. In this case it can't be changed in Cura of course.
Link to post
Share on other sites