Jump to content
Ultimaker Community of 3D Printing Experts

Ultimaker S5 Won't Power On


Recommended Posts

Posted · Ultimaker S5 Won't Power On

I recently wrote the attached thread, and the advice given to me by support was to reboot the printer.  I did, but now it turns on, shows the Ultimaker S5 logo and the material station lights up (notably not the load/unload buttons though), and doesn't progress.

 

Can I somehow factory reset this?  Note the web portal doesn't seem to load either.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...