Jump to content

mise à jour firmware S5


Recommended Posts

Posted (edited) · mise à jour firmware S5


je n'ai pas mis à jour le firmware depuis des lustres.

je viens de mettre sur une clé le firmware "rootfs-" et "rootfs-"

pour pouvoir mettre le firmware "um-update-6.3.0-R1.swu"


avec le fichier "rootfs 5.1.94 ......" cela fait 24h que l'imprimante affiche "ne pas étendre" mise à jour en cours "

je sens bien que ce n'est pas normal, mais quelle procédure adopter maintenant?

éteindre et voir si elle redémarre? 


qui a déjà rencontré ce problème?




Edited by francois1-1
  • Link to post
    Share on other sites

    Posted · mise à jour firmware S5

    I have just found my initial account "francois 1"
    no worries it's always me.



    i haven't updated the firmware for many years.

    I just put on a key the firmware "rootfs-" and "rootfs-"

    to be able to put the firmware "um-update-6.3.0-R1.swu"


    with the file "rootfs 5.1.94 ......" it has been 24 hours since the printer displays "do not extend" update in progress "

    I feel that this is not normal, but what procedure to adopt now?


    I try to turn off the printer.
    she restarted, the current firmware is

    the printer does not offer me an update while on the usb key I have the same files as at the beginning (rootfs and um update 6.3.0R1)

    how to update this firmware?

  • Link to post
    Share on other sites

    • 2 weeks later...
    Posted · mise à jour firmware S5
    On 5/6/2021 at 3:41 PM, francois1 said:

    it didn't work with the usb stick. I succeeded by wifi.
    subject resolved



    Good time for a spring cleaning, I hope you enjoy the new firmware!


  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
          • Like
        • 18 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    • Create New...