UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Yes, using the M28 command is extremely slow to the point of being useless. It isn't a Cura problem though. All printer/software combinations have the same problem. I wrote my own program to write to the SD but it wasn't any better. The printer mainboards aren't very capable when writing to the SD card.
Printing from Cura over the USB isn't too good either as buffer under-runs and over-runs can occur and there are other problems as well. If you want to print remotely then I guess the Octoprint/RaspberryPI combination is the best solution.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.Â
Â
Recommended Posts
GregValiant 1,287
Yes, using the M28 command is extremely slow to the point of being useless. It isn't a Cura problem though. All printer/software combinations have the same problem. I wrote my own program to write to the SD but it wasn't any better. The printer mainboards aren't very capable when writing to the SD card.
Printing from Cura over the USB isn't too good either as buffer under-runs and over-runs can occur and there are other problems as well. If you want to print remotely then I guess the Octoprint/RaspberryPI combination is the best solution.
Link to post
Share on other sites