UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
It sounds like you received a warped bed. One fix is to use shims (aluminum foil works). If you were to cut out a square piece of foil 235 x 235 and cut a hole in the center maybe 200mm diameter and lay it on the aluminum with the build surface on top, it would raise the periphery. If one piece doesn't work then try two. That would certainly be cheaper than buying a new hot plate.
Another fix is to go to a glass build surface (but you still might need to shim the corners or the glass might rock).
You might try going with an "Initial Layer Height" of .28. That's about the most you can go with a .4 nozzle.
You could remove the hot bed and try to take the "bow" out of it.
Finally you could replace the hot bed. The problem with that is there is no guarantee that the replacement would be any better.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
GregValiant 1,279
It sounds like you received a warped bed. One fix is to use shims (aluminum foil works). If you were to cut out a square piece of foil 235 x 235 and cut a hole in the center maybe 200mm diameter and lay it on the aluminum with the build surface on top, it would raise the periphery. If one piece doesn't work then try two. That would certainly be cheaper than buying a new hot plate.
Another fix is to go to a glass build surface (but you still might need to shim the corners or the glass might rock).
You might try going with an "Initial Layer Height" of .28. That's about the most you can go with a .4 nozzle.
You could remove the hot bed and try to take the "bow" out of it.
Finally you could replace the hot bed. The problem with that is there is no guarantee that the replacement would be any better.
Link to post
Share on other sites