Jump to content

the origin point


thetrollerman

Recommended Posts

Posted · the origin point

so i am not sure who i did it but i managed to set the print so that   the center of the print is on the edge of the bed so that 75% of the print is outside of the bed and area of possibility to print, so if someone could help me fix it that would be apricated. 

 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...