Hey gr5,
Thank you very much for your advice, I bumped up the thickness to 0.8mm and just as you said, it works!
Many thanks,
Yuzki
Hey gr5,
Thank you very much for your advice, I bumped up the thickness to 0.8mm and just as you said, it works!
Many thanks,
Yuzki
0.2? You mean 0.2mm layer height?
I was talking about the parameter "line width". You want that to be 1/2 as the width of the walls you are printing. Or smaller. But your fins were nice and thick - easy to print even with 0.6mm nozzle (and 0.6mm line width).
I might have been looking at the layer height, sorry. My line width is at 0.4mm and it is coming out fine on Cura. I've just began printing it now so I'll have to wait and see what happens but thank you very much for your help.
Recommended Posts
gr5 2,224
Works for me. What do you have for your line width? Even with 0.6mm line width it slices just fine for me.
Link to post
Share on other sites
Yuzki 0
Thank you very much for your response,
I am using a line width of 0.2mm, would that be why it doesn't work?
Many thanks,
Yuzki
Link to post
Share on other sites