Jump to content

Left mouse button stopped moving cura camera up and down.


Lord_of_Darkness

Recommended Posts

Posted · Left mouse button stopped moving cura camera up and down.

Hi All

 

I have reasently found a bug, when I try to move the camera up and down the left mouse has stopped doing this.  I was able to do this without pressing the shift key but now I need to press the shift key to do this but would like to go back to not pressing the shift key.

 

Thanks

  • Link to post
    Share on other sites

    Posted · Left mouse button stopped moving cura camera up and down.

    Are you sure you haven't mapped something like that in the past?

    For me it was always the behavior, Shift + left mouse button to move the around and right mouse button to rotate the view.

    Shift + left mouse is normally the middle mouse button if you have one and if I remember correctly. As a Mac user I never had a third mouse button 🙂 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 7 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    ×
    ×
    • Create New...