Jump to content
Ultimaker Community of 3D Printing Experts

Bug found in "Filament-Stuck-in-Printcore"-Procedure


Recommended Posts

Posted · Bug found in "Filament-Stuck-in-Printcore"-Procedure

Hello there.

I believe I have found a bug in the procedure that the pro bundle starts when the material station can't retract the filament out of the printcore.


I tried printing with BASF PET CF. Sadly the material profile for the material station ALWAYS fails at retract the filament out of the printcore after a finished print. First, I tried to edit the material profile to increase the Break temperature of the filament from 90°C to even 250°C with no change. Maybe I have to set a different Break retraction distance...?


Anyway, while I did all these tests I noticed that the procedure to recover stuck filament from the printcore seems to have a bug: at the end of the procedure the build plate almost "falls" to the ground (with a very unpleasant noise).


I recorded the end of the procedure. (Around the 0:28 mark)





  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    • Create New...