Ultimaker Cura Keeps Crashing

[PaciFrisk 0]

Hello! 

I have a AnyCubic i3 Mega X machine and  it recommended Cura as a Slicer. I do not have a SD reader nor does their USB flash drive work so I am forced to use USB connections. I  have started a print on Cura twice now, one was smaller and the second was bigger, and both time it crashed after barely setting up the base. Is there a way for it to stay on and keep from crashing? Since when it crashes, the print stops and I can not seem to find a way to resume it.  Is there a way to keep progress and resume it? That way, if it crashes, I can start it up again without wasting filament and time. 

[ahoeben 1,965]

What you could try is save the gcode to disk, and then use Printrun to print instead of Cura:

https://www.pronterface.com/