Jump to content

Disable Automatic Leveling on S3


Recommended Posts

Posted · Disable Automatic Leveling on S3

I am printing with conductive filament, which interferes with the capacitive leveling sensor and often causes the automatic process to fail (Ultimaker S3).  When I run the manual leveling setup, it still performs the automatic leveling before the print.  I would like to request that the manual leveling option disable the automatic leveling before the print, similar to how it was on the Ultimaker 3.  

  • Link to post
    Share on other sites

    Posted · Disable Automatic Leveling on S3

    You can also disable active leveling yourself: https://community.ultimaker.com/topic/23706-disable-automatic-active-bed-levelling-for-ultimaker-s5/?do=findComment&comment=293936

     

    Normally I don't recommend this as most pieces of glass are not flat and you need active leveling to map out the hills on the glass but you have a very special case.

     

  • Link to post
    Share on other sites

    • 2 weeks later...

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...