Odd issue near vertical edges

[Cohbra 0]

I am not sure what is causing this issue, but I am randomly getting small V notches next to some of the vertical edges in my prints.  They're located next to the thinner line widths (light green), which also shouldn't be any thinner than the rest of the surface.  As you can see in the SolidWorks model, these should not exist.

 

Any suggestions would be greatly appreciated.

 

[fvrmr 73]

Hi @Cohbra could you share your project file (file - save project) than I can take a look at it. 

Thank you in advance.