Cura show ghost point of the object if is it in horizontal position, but the object appear and print well only vertical position (or with more angle)

[john_vlahidis 0]

in this object If I slice on cura and print it horizontally the top nozzle does not appear and dont print (The "TOP" show ghost in cura) But if I slice at vertically appear correctly and after print ok. What happent?

I would like to print it horizontally for more resistance to the forces it will receive

 

Stl file and freecad 

⁠https://drive.google.com/drive/folders/12mamf73Ix2Y6qpzryt_gt9Jrok4c1mNs?usp=sharing⁠


My cura version MacOS 

[GregValiant 1,307]

It doesn't happen for me using a .4 nozzle and .4  Line Width.  When you orient it vertically then Layer Height is the limiting factor.  When it's oriented horizontally then Line Width is the limiting factor.

 

[john_vlahidis 0]

12 hours ago, GregValiant said:

It doesn't happen for me using a .4 nozzle and .4  Line Width.  When you orient it vertically then Layer Height is the limiting factor.  When it's oriented horizontally then Line Width is the limiting factor.

 

Thanks!