Jump to content

Firmware update - mains power failure...

rich080487

By rich080487
in Firmware

 Share

Recommended Posts

rich080487

rich080487 0

Posted
Posted · Firmware update - mains power failure...

My UM3 suggested a new firmware was available, so I chose to install it.

It hasn't be networked for a while, so I thought it was probably a worthwhile update.

Unfortunately during the firmware install, with "1 minute remaining", there was a mains power failure šŸ˜ž

Ā 

Now when switching on the machine the screen shows no sign of life, but I can hear the fans turning on.
Any thoughts on my next steps to get it working again? Or is it "bricked"?

Ā 

I have read a few posts about firmware uploading on this forum, but I can't use the USB and system settings as I can't get that far.

I am Mechanical Engineer with limited knowledge of Arduino.

Ā 

Any help appreciated. Thanks!

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.Ā 
        Ā 
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series Ā 
        New features
        Ā 
        Temperature status.Ā During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state.Ā It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, theĀ Dump logs to USBĀ option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory.Ā If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to selectĀ Confirm removalĀ on the printerā€™s display. VisitĀ this pageĀ for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...