The plastic at the start did not stop.

[curtism13 1]

Hi, so you know when you send  a job the to the printer, it calibrates, then heats up the print cores etc. but when it starts the "poop" does not stop coming. I do not know why but I need quite a lot of  help here.

 

Kind regards,

Max.

[Smithy 1,145]

There was or still is a bug in the firmware, that when you abort a print job and start a new one, then the prime blob extrudes too much. So I rebooted the printer always after I have aborted a print job to be sure. But it was not always, only sometimes.