-
Our picks
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
UltiMaker Cura 5.9 stable released!
ArunC posted a topic in UltiMaker Cura,
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more- 5 replies
Picked By
MariMakes, -
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications- 4 replies
Picked By
MariMakes,
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
Recommended Posts
GregValiant 1,410
Move the Z seam to a corner of the transom ("left front" or "left rear" when I load a Benchy) and use "smart hiding". It should move to a corner at the back of the boat and be far less noticeable.
The dark mark is where the deck is on the interior and it's been an issue on all Benchys. The more translucent the filament the more noticeable it is.
Link to post
Share on other sites