Question Issues with 4.11 on Ender 3 Pro

[mdwilson85 0]

I have an ender 3 pro. I upgraded to the new 4.11 and cannot get a good print on my ender 3. I went back to 4.9 and it prints just fine. 

 

On 4.11 my print shifts layers in the y direction 10 mm for each layer. I guess for my ender 3 I will keep using 4.9. Is anyone else having this same issue with any of their printers. Have any of you addressed this with the Ultimaker. I love using Cura and the mono feature is the bomb but sad I cannot use it on my Ende 3 Pro. First issue I have had with Cura in over a year. 

 

[GregValiant 1,415]

My printer is an Ender 3 Pro and I've had no issues  beyond the normal often reported "Won't slice single layer model".

A huge layer shift like that is pretty much guaranteed to not be in the gcode.

Check your Accel and Jerk settings from 4.9 to 4.11.