After filling the line segment, how to make it move in the nozzle, through what algorithm to make the filling line segment order
I was hoping for a Cura screenshot. That would tell me 30 things at once: for example if you are talking about support, infill, or skin (skin is top and bottom surfaces exposed to air). And your screenshot would show me an example of the problem you are talking about. And what your model looks like.
I don't understand your numbers which seem to skip randomly.
Normally Cura always does a zig zag pattern for the skin (example top or bottom surface of a cube). So you don't have to do anything.
Recommended Posts
gr5 2,224
I don't understand. Could you explain with a picture? A screen shot of Cura maybe?
Link to post
Share on other sites