New in Cura 4.11?

[jjRac00n 0]

I noticed that there now is a dark grey perimeter region (8mm wide in this case) where, if encroached, disallows slicing.  I have a model which requires diagonal placement to fit the build plate.  In 4.11 the model breaches this perimeter zone and is un-sliceable.  In Cura 4.10, there is no dark grey perimeter region and my model slices.  Can this new 'feature' be modified or disabled? How?

[Smithy 1,146]

This is not a feature of Cura 4.11 it is defined in your printer profile. So I guess the printer profile has changed between the 4.10 and 4.11.

[ahoeben 2,011]

It is likely because the buildplate adhesion setting is set to brim or skirt, whereas in 4.10 you had it set to none.

[jjRac00n 0]

That's it exactly! Thanks.