Jump to content

Broken Temperature Sensor ?


SpaceKnight

Recommended Posts

Posted · Broken Temperature Sensor ?

Hi,

i wanted some feedback for my problem analysis.

 

Printer: Ultimaker 2+ with about 8000h print hours

 

Everything was printing fine until suddenly i let the printer sit for holidays. When i came back nothing would stick to the PEI plate. I cleaned and tested everything. ( Extruder cleaned, build plate cleaned, new Nozzle).
I noticed the filament did not flow fast enough at the start of the print so i started turning the flow rate up and heard the extruder could not keep up. Following that i upped the temperature of the nozzle in 5°C steps until i hat 20°C+ and it suddenly worked. With that knowledge i suspect the temperature sensor is broken. I measured the thread of the block (with out a nozzle) a difference of 30°C. (Printer shows 210° reality 180°C) 

 

Is my conclusion right that the sensor is broken? Is this normal that this happens? Is it possible to just change the sensor ?
Thank you in advance :)

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...