UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
In Cura "panning" the camera is done by holding the shift key while dragging in the viewport (using the "left mousebutton", or just single finger dragging with the mousepad as if you were moving a model).
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
ahoeben 1,994
In Cura "panning" the camera is done by holding the shift key while dragging in the viewport (using the "left mousebutton", or just single finger dragging with the mousepad as if you were moving a model).
Link to post
Share on other sites
WartyNZ 4
Thanks ahoeben
Link to post
Share on other sites