UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
So the infill percentage must be non zero, the pattern must not be zigzag and you must either not use gradual infill steps or not connect the infill lines
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
nallath 1,124
Infill line multiplier can be disabled in a few cases:
So the infill percentage must be non zero, the pattern must not be zigzag and you must either not use gradual infill steps or not connect the infill lines
Link to post
Share on other sites
Mlogue9 3
OH MY GOD. ZigZag f;491ing hides it. Thanks man, your reponse was a bit cryptic but thanks a lot!!!
Link to post
Share on other sites