Jump to content
Ultimaker Community of 3D Printing Experts

Initial layer has bare areas and rough areas


medicalmodeller
 Share

Recommended Posts

Posted · Initial layer has bare areas and rough areas

I have an Ultimaker 3.  I have a BuildTak flex plate covered with PEI sheet.    I am currently printing ASA

 

My problem is that the first few layers are very inconsistent.   I have relevelled several times but its no better.   The metal plate does not look distorted.  Do I need a new plate or a complete set with magnets too???

20211129_125907.jpg

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...