UM3 sees wrong printcore

[Flutelab 4]

Hi everybody,

I had this nag message that I should not print tPLA on a BB printcore.  Cool, but I am not doing that so stop reminding me. Then I "changed printcores" . I took out the AA, waited, and put it back in. UM3 says a BB printcore was inserted. So UM3 thinks I have an AA printcore at extruder1, while really there is an AA present.

Someone knows whats going on?

BTW, prints fine.

best rtegards, Maarten

[Enigma_M4 120]

Hi Maarten,

it seems your printcore is programmed wrong.

There's a hopefully useful thread in this forum where some reprogramming procedures are shown:

I hope it helps.

Regards

[Flutelab 4]

Enigma_M4

I had not managed to find that thread with the forum search. But the CarloK solution simply sorted it out.

so: many thanks!

Maarten