Ender 3 v2 printer not reading the g code correctly on Cura

[ablakesley1 0]

Hello, I have and Ender 3 v2 and I have a feeling it is not reading my g code correctly- It worked previously ....but  my computer uninstalled my cura app- So after re-install- when I go to print, all my 3d printer does is spit the PLA out in the middle and doesn't make a design? 

 

I know it still works because my old gcodes that were downloaded before the crash work just fine and will print something.... but anything new that i try to upload and print just turns into a blob. So I assume its a setting on the new cura download after it crashed. Any ideas? 

[GregValiant 1,330]

Load a calibration cube or benchy in Cura, set it up to slice, then select "File | Save Project" and post the 3mf file here.